How To Turn Off A Husqvarna Automower For Winter: Easy Guide

For most U.S. homeowners, winter storage starts by stopping the Husqvarna Automower, switching it off, cleaning it, fully charging the battery, and storing the mower in a dry, frost-free place. Husqvarna also recommends protecting the charging station, power supply, and exposed electrical connections from snow, ice, and standing water.

The exact steps can vary by model, such as an Automower 115H, 310, 415X, 450XH, or Automower NERA. Always use the operator’s manual for your exact model before removing a battery, disconnecting wiring, or servicing the mower.

Table of Contents

When should you turn off an Automower for winter?

Turn off your Automower before regular snow, ice, or hard freezes begin. In much of the United States, this may be between October and December, but the right date depends on your local climate and grass growth.

Stop using the mower when:

Snow or ice is expected.
The ground stays frozen.
The lawn is too wet to mow without rutting.
Grass growth has stopped for the season.
Temperatures are regularly near or below freezing.
You will not use the mower for several weeks.

Do not wait until snow covers the charging station. Wet debris, ice, and frozen ground can make winter cleanup harder and may expose outdoor electrical parts to conditions they were not designed to handle.

Why winter storage matters

An Automower uses a rechargeable battery, a charging station, boundary equipment, and a power supply. These parts do not all need the same treatment.

The mower itself should usually be stored indoors. The charging station and power supply should also be protected from freezing weather when the model’s instructions call for indoor storage. The boundary wire can often remain in the ground, but its connectors and exposed ends need protection from moisture.

Husqvarna manuals and support materials are the best source for model-specific instructions. You can find manuals through the Husqvarna U.S. support center.

How to turn off a Husqvarna Automower step by step

Follow this sequence to prepare most Husqvarna Automower models for winter storage.

1. Let the mower finish or stop its current task

Use the Automower app or the mower’s control panel to stop mowing. If the mower is outside, guide it back to the charging station if possible.

Do not lift a running mower. Stop the blades before handling the machine.

2. Turn the mower off

The shutoff method depends on the model.

On many Automower models:

Press the STOP button.
Open the keypad or display cover.
Enter the PIN if requested.
Move the main power switch to the OFF position.

Some newer models may use a different control layout or app command. The physical power switch and operator’s manual take priority over general instructions.

After switching the mower off, wait for the blades to stop fully before touching the underside.

3. Clean the mower

Remove grass, soil, leaves, and other debris from the mower before storing it. Pay close attention to:

The wheels
The cutting deck
The blade disc
The charging contacts
The body openings
The area around the front wheel or wheels

Use a soft brush or a damp cloth. Do not use a pressure washer or a strong stream of water. Water forced into the housing can damage electronic parts, bearings, or seals.

If the mower is wet, allow it to dry fully before placing it in storage.

4. Inspect the blades and blade disc

Check the blades for wear, bending, or damage. Replace damaged blades before the next mowing season.

Husqvarna Automower blades are small and sharp. Wear gloves and keep fingers away from the blade disc. Disconnect power and confirm that the mower is off before turning it over or working underneath it.

You can replace worn blades before storage or at spring start-up. Replacing them before storage can save time when the lawn begins growing again.

5. Fully charge the battery

Place the mower in the charging station and allow it to charge fully before shutting it down for long-term storage, unless the manual for your model gives different instructions.

A full charge helps prepare the battery for storage. Do not leave the mower powered on and continually running a winter schedule.

Battery storage guidance can differ among models and battery types. Some models have user-accessible batteries, while others require battery service by an authorized technician. Do not remove a battery unless Husqvarna specifically allows it for your model and provides the correct procedure.

6. Remove the mower from the charging station

After the battery is fully charged, turn the mower off and remove it from the charging station.

Store the mower indoors in a location that is:

Dry
Clean
Protected from frost
Away from direct sunlight
Away from heat sources
Not exposed to fuel, chemicals, or corrosive vapors

A garage, basement, or utility room may work if it stays dry and does not freeze. Keep the mower away from places where water can drip onto it.

7. Protect the charging station and power supply

The charging station is not the same as the mower. Winter storage steps depend on your model and installation.

If the manual instructs you to bring the charging station and power supply indoors, disconnect them carefully and store them in a dry, frost-free location. Do not pull on the cable. Hold the plug or connector when disconnecting it.

If you leave the charging station outdoors:

Follow the exact instructions for your model.
Protect the power supply from rain, snow, and standing water.
Do not bury the power supply.
Keep connectors clean and dry.
Do not place a loose plastic cover over powered electrical equipment unless Husqvarna specifically approves that method.
Protect exposed connectors with the approved caps or method for your installation.

When in doubt, disconnect the system and store the electrical components indoors. Contact Husqvarna support or an authorized dealer if the wiring arrangement is unclear.

8. Leave the boundary wire in place when practical

In many installations, the boundary wire can stay in the lawn during winter. Removing it can create unnecessary work and may damage the wire or connectors.

Before winter storage, inspect the visible parts of the installation. Repair loose connectors or damaged sections according to the installation manual. Mark the locations of any connectors that remain outdoors.

Do not cut or disconnect the boundary wire simply because the mower is stored indoors. The boundary wire is part of the yard installation, not a normal battery-storage component.

What should you do with the charging station during winter?

Store the charging station and power supply indoors when your model’s instructions require it or when the installation cannot remain protected from freezing precipitation.

Husqvarna Automower systems differ. Some owners leave a properly installed charging station in place, while others remove it for winter. The correct choice depends on the model, power supply, connector design, weather exposure, and local installation.

Use this decision guide:

Situation	Practical action
The manual says to store the station indoors	Disconnect and store it indoors
Snow, ice, or flooding can reach the station	Remove it or protect it as the manual directs
The station is under a secure, weather-rated installation	Follow the model manual
The power supply is exposed to winter weather	Move it indoors or correct the installation
You are unsure which parts can stay outside	Contact Husqvarna support or a dealer

Do not assume that a charging station is fully weatherproof in every condition. Weather resistance does not mean protection from prolonged snow burial, flooding, ice buildup, or damaged cables.

How to disconnect the charging station safely

Turn the mower off.
Disconnect power at the approved plug or outlet.
Follow the manual for disconnecting the low-voltage cable.
Keep connectors clean and dry.
Label cables if several connections may be confusing in spring.
Store removed parts with the mower or in a marked container.

Do not work on outdoor electrical connections during rain or when the ground is wet. If the power supply, cable, or connector looks damaged, do not reconnect it. Have it checked by a qualified service provider or Husqvarna dealer.

Should you remove the Automower battery?

Usually, you should not remove the battery unless the instructions for your exact Husqvarna model tell you to do so.

Automower batteries are not identical across the product range. Some are designed for dealer service, while some models may have a removable battery compartment. Opening the mower without the correct procedure can damage the housing, wiring, or seals. It may also create a safety or warranty issue.

Use this rule:

If the manual does not describe owner battery removal, leave the battery installed.
If the battery is removable, follow the model-specific storage instructions.
If the battery is swollen, cracked, leaking, hot, or damaged, stop using the mower and seek service.
Do not charge a damaged battery.
Do not store a loose battery near metal objects, heat, or moisture.

Husqvarna’s official manual for your product should state whether the battery requires special winter care. If the manual is not clear, ask an authorized Husqvarna service center before opening the mower.

Should you keep the mower connected to the charger all winter?

Do not leave the Automower powered on and scheduled to run during winter. Whether the mower should remain in the charging station depends on the model’s storage instructions.

For long-term storage, many Husqvarna instructions direct owners to fully charge the mower, turn it off, and store it indoors. Some manuals also recommend charging the battery during storage at a stated interval. Others may specify a different process.

Check the manual for:

The required battery charge level
Whether periodic charging is needed
The recommended storage temperature
Whether the battery should remain installed
Whether the charging station should be disconnected
Any steps for restarting after storage

Do not use a generic charging interval as a substitute for the instructions for your model. Battery chemistry, mower design, and software can differ.

Winter storage checklist for a Husqvarna Automower

Use this checklist before putting the mower away:

Stop the mower.
Move it to the charging station.
Let the battery charge fully.
Turn the mower off.
Clean grass and dirt from the body and underside.
Inspect the blades and blade disc.
Replace damaged blades if needed.
Dry the mower completely.
Store the mower indoors in a dry, frost-free place.
Check the charging station and power supply.
Store those parts indoors if the manual requires it.
Protect outdoor connectors from water.
Leave the boundary wire in place unless removal is required.
Save the PIN and installation details in a secure place.
Check the manual for battery maintenance during storage.

A simple labeled box can help. Store the charger, connector caps, tools, spare blades, and installation notes together so spring setup does not become a search through the garage.

How to restart a Husqvarna Automower in spring

Before spring mowing, inspect the mower and installation before switching the system on.

Bring the mower to a clean, dry work area.
Inspect the body, wheels, charging contacts, and cutting system.
Check for cracks, corrosion, loose parts, or animal damage.
Inspect the charging station and power supply.
Check visible boundary-wire connections.
Install the station according to the installation manual.
Connect power only when the area is dry and safe.
Place the mower in the charging station.
Turn the mower on.
Check the date, time, mowing schedule, and cutting height.
Test the mower while you are nearby.

The mower may need time to charge before it can run. If the boundary signal, charging system, or app connection fails, do not repeatedly reset the system without checking the cables and manual first.

Common winter-storage mistakes

Avoid these errors when shutting down an Automower.

Leaving the mower outside

Snow, ice, condensation, and freezing temperatures can damage parts or shorten battery life. Store the mower indoors unless Husqvarna specifically provides another storage method.

Using a pressure washer

High-pressure water can enter areas that normal outdoor moisture may not reach. Use a brush and cloth instead.

Storing the mower with wet grass underneath

Wet debris can hold moisture against metal and plastic parts. Clean and dry the mower first.

Forgetting the power supply

Owners often remember the mower but leave the power supply exposed to snow or flooding. Treat the power supply and connectors as electrical equipment.

Removing the boundary wire without a reason

The wire can often remain in the yard. Unnecessary removal may create breaks, poor connections, or a difficult spring reinstallation.

Turning off power before the mower finishes charging

If the battery is not full, follow the model’s instructions before storage. A fully charged battery is commonly part of Husqvarna’s winter-storage guidance, but the exact process is model-specific.

Opening the mower unnecessarily

Do not open the battery compartment or electronics housing unless the manual gives a safe owner procedure. Use an authorized service center when the repair is beyond routine maintenance.

What if the Automower will not turn off?

If the mower does not respond, first press the STOP button and keep clear of the blades. Wait until all movement stops.

Then try the following:

Keep the mower on a level surface.
Check whether the display or keypad is locked.
Enter the PIN if requested.
Follow the model’s normal power-off procedure.
Disconnect the charging station only after the mower is stopped.
Check the operator’s manual for a forced-shutdown procedure.

Do not reach under the mower while the blade disc can move. If the mower remains powered, smells hot, shows a damaged battery, or behaves unpredictably, stop troubleshooting and contact Husqvarna support or an authorized dealer.

What if the mower will not charge before storage?

Check that:

The charging station has power.
The mower’s charging contacts are clean.
The station is level and correctly installed.
The mower is seated correctly.
The power supply and cables show no visible damage.
The display does not show a specific charging error.

Clean contacts with a dry cloth. Do not scrape them aggressively or spray cleaner into the connectors. If charging still fails, have the system inspected before storage.

Frequently asked questions

Can I leave my Husqvarna Automower outside during winter?

It is generally better to store the mower indoors in a dry, frost-free location. The charging station and power supply may also need indoor storage, depending on the model and installation. Check the exact operator’s manual.

Do I need to remove the boundary wire for winter?

Usually, no. The boundary wire can often stay in the ground. Protect its connectors and exposed ends, and repair damage before spring.

Should I charge the Automower before turning it off?

Yes, Husqvarna winter-storage instructions commonly call for a full charge before long-term storage. Confirm the required procedure for your model.

Can I store the Automower in an unheated garage?

Only if the garage stays dry and does not expose the mower to freezing conditions that conflict with the model’s storage instructions. A dry, frost-free space is the safer choice.

How often should I charge the battery during winter?

The answer varies by model and battery system. Check the operator’s manual for any required charging schedule during storage. Do not guess if the manual gives a specific interval.

Conclusion

To turn off a Husqvarna Automower for winter, stop the mower, fully charge it, switch it off, clean and dry it, and store it indoors away from frost and moisture. Follow the model manual for battery care and for removing or storing the charging station.

Before spring, inspect the mower, cables, boundary system, and charging station. If any electrical part or battery looks damaged, do not reconnect it until Husqvarna support or a qualified technician has checked it.